ONE-TOUCH TOUCH SCREEN MONITOR TSM-1

The Touch Screen is a 12 inch LCD, full colour VGA monitor, mounted in a black ABS housing.

The Touch Screen monitor is connected to the CPU-1000 via a 15 and 9 pin D type connection.  The maximum distance between the TSM-1 and the CPU-1000 is 5 metres.

The Touch Screen monitor can be either wall or desk mounted, for ease of installation.

ONE-TOUCH CENTRAL PROCESSING UNIT CPU-1000

The Aqualarm One Touch Central Processing Unit shall be wall or floor mounted and be of a mild steel construction and powder coated.

The CPU-1000 combines the latest addressable CAN BUS technology for monitoring and displaying    information of alarms/alarm conditions within the running protocol of a Windows ® program.  It will be capable of monitoring up to 25 detectors from the full Aqualarm range including water, refrigerant gas, fuel oils, temperature and humidity as well as up to 25 i-Zone Control Panels or APM-25 Area Power Modules resulting in a combined monitoring power of up to 650 detectors.

The CPU-1000 can also monitor up to 25 LS-2i LeakSense Control Panels or ZLM-500 Zone Locating Modules, to create a fully comprehensive locating system.

When alarm conditions are raised, they will be displayed on the TSM-1 Touch Screen Monitor, with the use of detailed layout maps for the area(s) being protected.  Alarm history is stored on the unit’s own internal hard disk drive for future perusal.

Operating instructions, commissioning, maintenance and service logs are all stored electronically on the system for ease of retrieval and use.

The system is supplied with 5 volt free outputs, and a RS-485 output to relay alarm conditions to other controls such as Building Management Systems.

As the CPU-1000 is essentially a PC based product we strongly recommend the power supply is either connected directly to the building UPS system or an aftermarket proprietary unit which is purchased to support the system should the mains be interrupted or fail.

ONE-TOUCH AREA PROCESSING MODULE APM-25

The Aqualarm One Touch Area Processing/Power Module shall be wall mounted and be of a mild steel construction and powder coated.

The APM-25 combines the latest addressable CAN BUS technology for monitoring information of alarms/alarm conditions within the running protocol of a Windows ® program.  It will be capable of monitoring the full range of Aqualarm detectors including water, refrigerant gas, fuel oils, temperature and humidity as well as other devices capable of producing a volt free alarm output.

The APM-25 is capable of monitoring 25 zones/addresses.  This unit must be used in conjunction with the CPU 1000 Central Processing Unit.

When alarm conditions are raised, they will be relayed to the CPU-1000, which in turn will display them on the TSM-1 Touch Screen Monitor, with the use of detailed layout maps for the area(s) being protected.
For remote signalling, the control panel will be supplied as standard with the following outputs: RS-485, Common Alarm, Network Failure, Mains Fail and Service Required.